Muhammad Umer Jamil Email & Phone Number

A control system upgradation project which involved the retrofitting of existing control systems (T20 and MicroZ) on DCS with latest GE Rx3i based control system. Technically and strategically involved in all aspects of the project gaining Engineering, installation and testing experience during this tenure. Involved in the on-site FAT with GE Control TAs and engineering personals.

Worked as on job trainee engineer in Instrumentation and Control section of block 2 (4x GE 9E, 4x HRSGs and 2x Alstom Vega 209) at KAPCO reporting to Principal engineer I&C. Technically involved in all I&C maintenance activities. Supervised in the I&C related activities performed during Major Over Hauling of GE Gas turbine 9E according to Departmental protocols, Handling related Job cards etc. Support in areas like troubleshooting, fault analysis, Procurement and stock… Show more Worked as on job trainee engineer in Instrumentation and Control section of block 2 (4x GE 9E, 4x HRSGs and 2x Alstom Vega 209) at KAPCO reporting to Principal engineer I&C. Technically involved in all I&C maintenance activities. Supervised in the I&C related activities performed during Major Over Hauling of GE Gas turbine 9E according to Departmental protocols, Handling related Job cards etc. Support in areas like troubleshooting, fault analysis, Procurement and stock management, budget planning and management, future projects and strategies. Planning and technical work execution ensuring all aspects of IMS (quality, safety and environment). Hand zone experience and deep understanding of following areas: MARK IV and MARK VIe control system on GE Gas turbines ALSPA ControSteam V3 and (T20& mizcroZ) BOP control systems on Steam turbines Control logics and working principles Open loop and control loop drawings Field instrumentations and field wiring drawings Hardware customization and software configuration of MARK Vie control system using TOOLbox ST operating system. Calibration of field instrumentation and Precision Calibration Lab instruments Show less

Islamabad,Pak

Worked as an Embedded system developer at LCC (A TalkPool company providing Telecom services in Pakistan). Leading a team consisting of technicians and field worker responsible for the product development and project plan execution. Firmware development of products regarding power management installed at MSEs sites of JAZZ and Telenor. Hardware development using Altium software. Testing regarding both hardware and software (fault analysis and future… Show more Worked as an Embedded system developer at LCC (A TalkPool company providing Telecom services in Pakistan). Leading a team consisting of technicians and field worker responsible for the product development and project plan execution. Firmware development of products regarding power management installed at MSEs sites of JAZZ and Telenor. Hardware development using Altium software. Testing regarding both hardware and software (fault analysis and future improvements) Schematic designing and prototyping. Show less

Involved as a I&C supervisor during major overhauling MOH of Steam Turbine (RATEAU VEGA 209) and HGPI of Gas Turbines (GE ALSTHOM 9001E). Responsible for all I&C outage activities like all field instrumentation calibration, control specification verification and protocols. Successfully completed all outage activities

Bachelor'S Degree, Electrical And Electronics Engineering

Master'S Degree, Electrical Engineering

High School, Fsc, 89.2%

Matriculation, Sciences