Experience with UL, CSA, EN and IEC product safety projects and approval processes • Technical knowledge of domestic and international product safety standards, such as ITE (60950-1/62368-1) Worked with third party testing agencies such as UL, CSA, and TUV to achieve safety certifications under the SMT, CTDP, and WMT accredidation programs. Developed comprehensive and detailed test plans for use during cross functional meetings. Identified potential safety design hazards and worked in parallel with design engineers to ensure that any potential issues are minimized during development phases Addressed and rectified any variation notices provided during factory inspections to ensure that all non compliances would cause any impact to the manufacturing lines. Engaged with U.S Customs and Border Protection agents to ensure that all applicable paperwork and required documents including FDA letters and Safety reports are all provided prior to requests to ensure that there are no products held at customs. Organization and prioritization of product testing to meet program schedules. Acted as the laboratory calibration contact ensuring that all test equipment is accounted for and operating within the expected tolerances within the calibration schedule.

Independently performed testing and evaluation of various products to U.S., Canadian and other international product safety standards.Set up and operated standard test equipment including, but not limited to spectrum analyzers, oscilloscopes, dielectric strength testers, grounding continuity testers, digital multi-meters, surge generators, over-voltage testers, environmental condition chambers and articulated probes.Determined the applicability of National Code standards to the equipment under test.Conducted thorough construction reviews and documented the results throughout the evaluation.Analyzed and evaluated client provided schematics and manufacturing instructions.Communicated project status and test results by use of emails, phone conferences, and direct in-person meetings to the client, sales team, and management throughout testing duration.Completed preliminary and full design reviews at various testing locations and client manufacturing sites.Elected team safety coordinator to ensure that engineers and technicians follow and uphold all the requirements prescribed by the 5S+1 safety guidelines.Identified and located testing instruments required for testing.