Q.C. Mechanical InspectorTrend TechnologiesAs a Q.C. Mechanical Inspector these are some of my assignments:● In process inspection of parts and assemblies at different stages of production: Punch Press, Laser Machine, Press Brakes, Hardware, Machining, Spot Welding etc.● In process Inspection of cabinets for dimensions, fit and function, hardware, spot-weld, welding● First Articles for new products.● Weekly report for some internal NCMR’S.● Collecting data for critical dimensions of some parts.● Receiving Inspection for some products.Quality Control SupervisorCoastline Metal Finishing Inc.● Maintenance of Quality system including but not limited to:● Internal audits for AS9100 and NADCAP.● Calibration control of company tools and equipment.● Internal and externals NCMR reports.● Internal and customer CAR when required.● New employees introduction training to QA system.● Employee ITAR and FOD training and annual training records.● Customer surveys and process checklist.● Customer Satisfaction surveys.● Customer Service● Approved supplier list and periodic surveys.● Reviewing planning for job travelers.● In process inspection.● Issue PO’S for outside special processes.● Corporate Weekly QA reportsQ. C. Mechanical InspectorCalifornia Chassis Inc● As a Q. C. Inspector for California Chassis Inc. these are some of the assignments I was responsible for:● In process production inspection of EMK Punch Press, Laser Machine, Press Brakes, Hardware, Machining, Spot Welding, Welding and Pre-assembly Departments.● Receiving Inspection for incoming products from CCI-Tecate Plant, special outside processes ● Final Inspection of products.● Calibration of the company inspection tools and equipment.● Maintenance of the Internal NCMR'S file.● Internal and Customer F. A. I. reports.● Employee Training for the Introduction to the Company Quality Policy, Objectives and Safety.● Internal Audits for the ISO 9001 Std. requirements.