Departamento: Ingeniería Mecánica, Química y Diseño Industrial.Área de conocimiento: Expresión Gráfica en la IngenieríaProfesora en curso de verano internacional "AI-Driven Design: From Foundations to Ethical Innovation"

- Servicio de calibraciones internas al centro- Desarrollo de proyectos I+D+I en la Unidad de Sistemas Inteligentes - Soporte electrónico

- Cooperative systems as support for safe transitions between automatic and manual modes in autonomous driving. Human factors and eyetracking. - Instrumentation and vehicle automation in different projects. Low level control, hardware modification and installation of control commands. - Doctoral thesis on the subject "Influence of available information on decision-making in an autonomous vehicle". Participation in major research projects:- Distributed arbitration system for connected and autonomous cooperative driving in complex environments. Funded by the Ministry of Science and Innovation. National R&D&I Plan.- AUTO-BUS. Autonomous operation of urban buses within a depot for refuelling, washing, workshop and parking. Funded by the Centre for the Development of Industrial Technology (CDTI).- ESTIBA+2022. Development of i4.0 technologies for the digitalisation of Spanish ports through highly automated logistics (Smart Digital Ports). Funded by the Centre for the Development of Industrial Technology (CDTI).- TUNNELAD. Tunnel Autonomous Driving. RTC-2017-6382-4. Funded by the Ministry of Science, Innovation and Universities.- SICOTRAM. Cooperative systems as support for safe transitions between automatic and manual modes in autonomous driving. Ref. SPIP2017-02324. Funded by the National Traffic Directorate.- REMOTE-DRIVE-2. Evolution of the REMOTE DRIVE demonstrator to obtain its standardisation and multiplatform installation capacity. Ref. 1003219004800. Funded by the Directorate General of Armament and Material of the Ministry of Defence (DGAM).- REMOTE-DRIVE. Drive-By-Wire for the remote guidance of conventional vehicles in advance terrain prospecting missions and pre-programmed driving through waypoints. Funded by the Directorate General of Armament and Material of the Ministry of Defence (DGAM).

Mentee in iXPA Master (International Specialization Programme in Projects Administration) by Acciona Group

Estancia predoctoral en el Departamento de Factores Humanos- Análisis de estrategias visuales en conducción parcialmente automatizada- Colaboración en la recolección de datos en el estudio sobre efectos del CO2 en el estado del conductor

Project: Design of ground control stations (GCS) of unmanned aerial vehicles (UAS) considering ergonomic aspects. Human Factors Laboratory. Metrology Area.

Project: New topology modelling and design flow of hybrid energy storage system combined with Li-ion battery and supercapacitorFP7_ITN_Marie Curie_ Early Stage Researcher at EMVeM project. http://www.emvem.org/Faculty of Electrical and Computer Science Engineering, Transilvania University of Brasov, Romania

Project: NVH analysis techniques for design and optimization of hybrid and electric vehiclesCOST Action TU1105. http://www.cost.eu/COST_Actions/tud/TU1105Faculty of Mechanical Engineering Department, Transilvania University of Brasov, Romania

Study, review and documentation of reports and tests related with the reforms and individual approvals in vehicles.

Energy Performance Certificate for existing buildings, software CE3X. Engineering projects. Building measurement certificates.

2nd call. Collaboration scholarship of "Aid the realization of practices in activities to promote research in Departments and University Institutes of the Miguel Hernández University in Elche" by the Vice President of Students and Sports. - Simulation of models 4DOF and 6DOF, observing the influence of the mass of the motor on the suspended mass. Analysis of significant parameters on the vertical dynamics. - Collaboration in article in "XX National Congress of Mechanical Engineering". September 2014.

1st call. Collaboration scholarship of "Aid the realization of practices in activities to promote research in Departments and University Institutes of the Miguel Hernández University in Elche" by the Vice President of Students and Sports. - Development of a bibliographic database used in the research line "Monitoring the deterioration and aging of systems includes the motor vehicle", part of the Group "Applied Mechanical Engineering", led by Dr. Emilio Velasco Sanchez. - Design of mathematical models of various degrees of freedom in Simulink/Matlab, using the Bond-Graph method in a quarter and a half vehicle. - Processing of experimental data with accelerometers bank suspensions M.O.T.

Control of production, processing procedures of Labour Risks Prevention, management and administration of raw materials. Quality and production department.

Situation analysis and preparation of manuals, studies, reports, drawings and claims in different departments. Substitution in the warehouse of raw and auxiliary materials.

Elaboration the dissertation in a research line on the suspension of a vehicle, using material from the Laboratory of Vehicles to realise experimental testing.