David Gregory Email & Phone Number

Fridley MN

Fridley MN

I am programming the Mitutoyo DCC CMM with PH9 head, using MCOSMOS software. We machine airplane cylinder heads only. Very tight tolerance. I do all setup and in-process inspection. I oversee final inspection, checking and recording 100% on critical dimensions. I insure that all parts & operations are 100% traceable.

Fridley

This was a one-person inspection department. I did setup inspection, in process inspection, final inspection, gage calibration. I prepare ISIR, including PPAP requirements. I learned the Romer Arm CMM with Brown & Sharp PC DMIS software. I handled the RGA system. I was part of the team that investigated with Root Cause Analysis tool and then followed up.

Plymouth Mn.

I supported the ISO 9001 2008 QMS. I did contract review on all new projects. I would be the liaison that supported John Deere in the prototype of their new joystick. I reviewed and verified more than 70 prints from 3 different design engineers. The profile of the joystick and mating parts were tight tolerance with complex geometric datum structures. About.

MPLS AFTD

Quality Technician. I Programmer the CMM Brown & Sharp with PC DMIS software. I also programmed the Zeiss CMM. I did First Articles & in-process inspection. I trained all machinist on proper use of Fowler Digital Trimos, Optical Comparators with Smart Scope, Mitutoyo Form Measurement System, Profilometer, and other. Than sighed them off on training.

Brooklyn Park Mn.

This was a one-man Quality Department. I oversaw internal and external audits. I put together the paperwork for government source inspection. I programmed the Mitutoyo DCC CMM using Fixture Coordinate Systems with a SPC data package. I prepared PPAP for the military & automotive Industry. I oversaw Source Inspection. The packets including FMEA, First.

Fridley Mn.

Maintained the ISO certification. Including Programming of the DCC Mitutoyo CMM & Implementation of SPC software within the operating system. Monitored the floor for process capability and did all calibration and repair of company and employee tools.

Fridley MN

Responsible for programming the DCC Mitutoyo PH9 CMM. It was my job to set up this complex CMM using fixture coordinate systems to enable it to be user-friendly. After this, the machine operators would have easy access in checking their own complex parts. I also did all other aspects of inspection, including writing Inspection Procedures, Gage Control.

Greater Minneapolis-St. Paul Area

I had the responsibility for quoting and completing all contract inspection. The inspections were done using a Numerex CMM, open-plate or standard measuring equipment. I would then present the results to a customer service representative. I also did calibration on customer supplied gages, including gage blocks. The gage blocks could be checked with gage.

Hover St Mpls

This was a very complex machine shop. Sheet metal, welding, machining, paint, hardware, silkscreen, assembly and more. These parts were aerospace, military, NASA parts. I worked directly with Source Inspection. I would view the purchase orders requirements. Then review new traveler, follow through with in-process inspection, gathering data for final.

40 Hour Cources, Geometric'S Gdt, Introduction To Spc, General Requiremens For Quality, Computer In Quality Control, A

1982, 1986, 1989 – Minneapolis, MN; Hennepin Technical College – Geometrics GDT . Taken the course three times. 108 hours training, and.

One Year Technical Degree, Precision Inspection & Materials Testing ( Ndt), A

General Studies

Asqc Certifed, Mechanical Inspector, A