Kumar Gowda Email & Phone Number

Singapore

Singapore

• Working for FSRU (REGAS), LNG Bunker vessels, LNGC and Reliquefaction projects.International codes and standards like IGC, IGF, OCIMF, SIGTTO, NFPA-58 and 59A, BV Rules, BV rules and ABS Rules for LNG Bunkering
• Familiar in development of 3D-modeling using 3D software for Piping, Mechanical, Safety, Soft Volumes, Escape & Access ways & Material Handling Routes, Equipment modelling, Package modelling with required interface.
• Prepare 2D Drawing and check for Plot plan, Equipment plan, Isometrics and pipe supports drawings by using AutoCAD / Micro station.
• Design Review on regular basis by using Navisworks for establishing the Layout / Piping design in accordance with P&IDs and meet the project requirements.
• Interface with Process engineer, Mechanical Engineer, Safety Engineer and Project Engineer for the assigned Module / Area.
• Preparation of Hazardous zone identification drawings and followed points to be updating as per referred Code/Rules.

Singapore

• Project Manga Torinio LNG Terminal Client: Wärtsilä (LNG Storage tank topside piping layout basic design)Project Leviathan 1st phase devolopment-BW offshore Norway (3 months extendable deputation) Client: Nobal.
• Consistency review of piping GA and isometric with respect to P&ID.
• Consistency review of piping Equipment layout & plot plan.
• Review of vendor drawings and co-ordination with other departments
• Checking of isometrics.
• Preparation & checking Piping bulk MTO

Hyderabad Area, India

• PDMS modeling of piping & equipments according to P & ID’s and extracts isometric drawings.
• Providing Tie in points for equipment in PDMS as per Vendor Drawings.
• Planning, Modeling & Updating of Instrumentation air, Utility water, Raw water and Drain lines.
• Preparation of the general arrangement drawings for piping using PDMS draft & AutoCAD.
• Preparation of Nozzle orientations drawings for equipments.
• Preparation of Pipe support In Multi disciplinary Support(MDS)

Hyderabad Area, India

• 3D Modeling of Piping in Utility system like Nitrogen lines, DM lines, RW lines, FW lines,Air utility etc.
• Modeling of Equipment’s as per Equipment Layout.
• Preparation of Nozzle orientation Drawings.
• Piping support adequacy checks, integrity of the equipment under revised process conditions.
• Study of Process P & ID & Utilities P & ID.
• Providing extra support for the piping system.

Diploma In Mechanical Engg, Mechanical

Education record