I'm working as an industrial Automation engineer with 10 years experience in erection, commissioning, operation and maintenance and automation(Power, distillery,chemical, petrochemical, paper and sugar) with Electrical, instrumentation, PID controller, motor, analyzer VFD, Flow metre,dpt, calibration, PLC programming, DCS programming, HMI,softstater,transformer etc.Job involves Analysis, Designing, Implementation and Commissioning of a wide range of software and hardware projects for Solar Power Plant, CHP(Coal Handling Plant)/ Process Automation/Mining and Minerals/Equipment's Automation.# Project Planning and System architecture design and Implementation# Technical discussion with customers for the project implementation.# Arrange, Depute and handle the team members.# Technical support in implementing the project.# R & D at the office for customer requirements.# Determining the 10 count for PLC from P&ID.# 10 allocation, Module allocation, process segregation for 10 allocation.# Client correspondences.# Developing logical function blocks for typical motors, PID controllers, control valves, etc.# Conducting FAT / SAT.# Commissioning support# PLC & SCADA Software development.#800xASystem Setup#Server and client Configuration#Industrial communication Protocol like (Modbus TCP/IP, RTU, Serial, Profibus, Profinet,)#IEC6113-13 Languages for Logic# OPC(OLE for Process Control) UA & DA# Supervision of installation work# Start up and commissioning# Customer Support of existing Installation